VERTICAL BRIDGE CARD

This card was a team challenge for my team but I would challenge you to create it using the beautiful supplies you have. It is a very quick and easy card to create and fun to experiment with different papers. The one I used here is the NEW Sand and Sea Designer Series Paper. It only takes a sliver of DSP so you could create TEN cards from one sheet

Cut 11 x 4 1/4 Rococo Rose, cut @ 7, score @ 5 1/2 then

Out of the piece you cut off, cut (2) 4 1/4 x 1 1/2 pieces

Cut (2) 4  x 1 1/4 Basic White

Cut (2) 1 1/8 x 3 7/8 Designer Series Paper, adhere to Basic White

Cut (1)  2 5/16 x 1 1/4 Basic White

Cut (1) 2 3/16 x 1 1/8 Designer Series Paper, adhere to Basic White

Cut (1) 5 1/4 x 4 Basic White, attach to inside card

Attach one of the 4 x 1 1/4 Basic White, with the Designer Series Paper already attached to the front flap

Fold over front flap over the back of the card, lay on the table, place one of the 4 1/4 x 1 1/2 Rococo Rose at the bottom and paper clip to hold in place, adhere the other 4 1/4 x 1 1/2 Rococo Rose between the top and bottom to form a bridge

Turn right side out and adhere the remaining pieces

Finish off with a bow of coordinating ribbon and the Opal Rounds

Here is another sample

I finished off with the Resin Hearts

Below are the products I used to create this cute card

Check out the NEW 2020-21 ANNUAL CATALOG

January - June 2021 Mini is fabulous!

Sale-A-Bration is HERE! Don’t miss the deals!
Subscribe to my My YouTube paper crafting video channel
Follow me on Pinterest

Follow me on Facebook every week for Stampin' Tell Tuesday
Shop my Online Store with February's Host Code MERT9ST4